This is the mail archive of the crossgcc@cygnus.com mailing list for the crossgcc project.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
From: Dr_George_D_Detlefsen Subject: libgloss configure > Has anyone succeded in getting 'libgloss' to configure and make for > any targets ??? Look at the configure.in scripts used by the other ports, I'd suggest the m68k one or the sparc one. At the top there is a few lines of code like: if test "${srcdir}" = "." ; then if test "${with_target_subdir}" != "." ; then libgloss_topdir="${srcdir}/${with_multisrctop}../.." else libgloss_topdir="${srcdir}/${with_multisrctop}.." fi else libgloss_topdir="${srcdir}/.." fi AC_CONFIG_AUX_DIR($libgloss_topdir) This is how it'll find install.sh. Where did you grab libgloss from ? It could be out of date, as I haven't done an official net release yet. > 'arm-bare-aout/libgloss/arm' directory fails while attempting to > find 'install.sh' or 'install-sh'. > > The same problems occurs when attempting configurations for 'm68k' and > 'sparc' targets. Ah.. install.sh needs to be in the top level directory with config-ml.in and other stuff. - rob -