This is the mail archive of the crossgcc@cygnus.com mailing list for the crossgcc project.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
> AFAIK the m68k simulator you mention is the only free m68k simulator still > being developed/supported by anyone. Last time I looked for one, the > only option I found was the one from SDS. Presumably, you are talking about commercial ones here, since SDS isn't free. There are quite a few around - my recommendation would be to check Embedded Systems Programming magazine (especially the buyers guide issue) for commercial simulators, if that's what you are interested in. Clearly, SDS falls into this category. The one I am most familiar with is Xray from Microtec, which is known to support GCC. A much better debugger than GDB, too, but I will admit to being biased in this area, since I used to be Director of Product Development at Microtec. > As I recall, both product lines were Windows-based. I seem to recall that > the m68k was available under some unix's but there were some gotcha's under > unix. But there are other commercial 68K simulators available on various Unix platforms (see above). > Offhand, I don't even remember what the companies anacronyms stand for. SDS = Software Development Systems SSI = Systems and Software, Inc. -Ken Kenneth F. Greenberg, President California Advanced Software Tools, Inc. Los Gatos, CA, USA