Accessing Wiggler from Linux GDB

[Hans - Dulimarta <dulimart at egr dot msu dot edu>]

I'd like to know whether anyone could share his/her success story
accessing Macraigor's wiggler from GDM running on Linux. I have tried the
following two methods without any good luck:

1. From gdb 4.18 by running "target ocd /dev/lp0; target ocd wiggler
   /dev/lp0". The debugger seemed to hang after printing the message 
      "Remote target wiggler connected to /dev/lp0"

2. From Linux BDM-driver patched gdb mentioned in the Cross GCC FAQ.
   After running "target bdm /dev/bdm0" a kernel message 
      "Device or resource busy" was displayed.

Also, I'd like to hear from you who successfully accessed the Wiggler from
Cygwin GDB running on Win95/98 (not WinNT).

Thanks a lot.

-- 
Hans Dulimarta, Ph.D.        dulimart@[egr.msu.edu, computer.org]
                                 http://www.egr.msu.edu/~dulimart 
Visiting Research Associate,  Electrical & Computer Engineering
Michigan State University, East Lansing, MI 48824, (517) 432-7589


------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com