This is the mail archive of the crossgcc@sourceware.org mailing list for the crossgcc project.
See the CrossGCC FAQ for lots more information.
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
Other format: | [Raw text] |
I'm using Crosstool-NG 1.8.2 to get a cross toolchain for a BeagleBoard. I'm trying to verify the NEON support. I've enabled the following two configuration options: CT_ARCH_FPU="neon" CT_CC_CORE_EXTRA_CONFIG="--with-fpu=neon" However, when I try to build the xorg omap driver I get the following error: CC sw-exa.lo {standard input}: Assembler messages: {standard input}:105: Error: bad instruction `vld1.u8 {d0},[r1]!' {standard input}:108: Error: bad instruction `vld1.u8 {d1},[r4]!' {standard input}:109: Error: bad instruction `vld1.u8 {q1},[r7]!' {standard input}:110: Error: bad instruction `vzip.u8 d0,d1' {standard input}:111: Error: bad instruction `vld1.u8 {q2},[r6]!' {standard input}:112: Error: bad instruction `vst2.u8 {q0,q1},[r5]!' {standard input}:113: Error: bad instruction `vmov.u8 q1,q2' {standard input}:114: Error: bad instruction `vst2.u8 {q0,q1},[sl]!' make[5]: *** [image-format-conversions.lo] Error 1 I think this means that neon is not enabled, but I can't be sure yet. Is there some test I can run to check if the neon support is correctly turned on? The complete config file is on my site: http://www.graphics-muse.org/source/xcc/xcc.cfg.1.8.2 Thanks. -- Michael J. Hammel <crosstoolng@graphics-muse.org> -- For unsubscribe information see http://sourceware.org/lists.html#faq
Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
---|---|---|
Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |