This is the mail archive of the
cygwin
mailing list for the Cygwin project.
Re: gdb-7.3.50-1 can't read debug info for gcc-4.5.0-1 (exp)?
- From: Ryan Johnson <ryan dot johnson at cs dot utoronto dot ca>
- To: cygwin at cygwin dot com
- Date: Fri, 05 Aug 2011 09:32:29 -0400
- Subject: Re: gdb-7.3.50-1 can't read debug info for gcc-4.5.0-1 (exp)?
- References: <4E3BDAEC.8040302@cs.utoronto.ca>
On 05/08/2011 7:58 AM, Ryan Johnson wrote:
It seems that the latest release of gdb doesn't quite get debug info
right when reading apps compiled with the experimental gcc-4.5
package. It's a lot closer than the old gdb was able to get, but
reported line numbers are usually off by 3-5 lines and breakpoints are
similarly affected.
Is there some obvious reason I shouldn't expect this to work, and have
other people seen similar problems? If the answers are "no" and "no"
I'll start trying to isolate a small test case, and meanwhile I'm
building a gdb from scratch which I'll report back on.
Huh. Seems to have been a fluke... now that I've built a gdb-7.3 from
scratch, both it and the cygwin version work equally flawlessly. The
only things that have changed are that I rebased my system because the
gdb build was spawning fork failures left and right, and I recompiled
the binary (maybe with different flags? the flags I used before were in
an emacs session which I had to close to rebase). I don't know why the
former would affect anything, and I'll remain skeptical of the latter
unless I stumble across another magic combo of "bad" compiler flags (I
wasn't doing anything crazy or unusual in that area).
Sorry for cluttering up the list with this.
Ryan
--
Problem reports: http://cygwin.com/problems.html
FAQ: http://cygwin.com/faq/
Documentation: http://cygwin.com/docs.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple