This is the mail archive of the
cygwin
mailing list for the Cygwin project.
Re: FAO perl-XML-SAX maintainers: request for pre-filling ParserDetails.ini
- From: Achim Gratz <Stromeko at nexgo dot de>
- To: cygwin at cygwin dot com
- Date: Mon, 09 Apr 2018 19:53:16 +0200
- Subject: Re: FAO perl-XML-SAX maintainers: request for pre-filling ParserDetails.ini
- References: <20180409133440.GA2806@dinwoodie.org>
Adam Dinwoodie writes:
> Would it be possible for the perl-XML-SAX package to add a post-install
> step per <http://perl-xml.sourceforge.net/faq/#parserdetails.ini>?
Sure, it is possible. :-)
> Specifically, the instructions there say:
>
>> If you are packaging `XML::SAX` in an alternative distribution format
>> (such as RPM), your post-install script should check if
>> `ParserDetails.ini` exists and if it doesn't, run this command:
>>
>> perl -MXML::SAX -e "XML::SAX->add_parser(q(XML::SAX::PurePerl))->save_parsers()"
>
> This would avoid the (apparently benign but irritating) error message I
> see when attempting to build things like the Git documentation
> complaining that the system "could not find ParserDetails.ini".
Hmm. I'm not too sure this would work correctly in the face of other
changes in the installation. But then again it's better than nothing.
Regards,
Achim.
--
+<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk Blofeld]>+
SD adaptation for Waldorf rackAttack V1.04R1:
http://Synth.Stromeko.net/Downloads.html#WaldorfSDada
--
Problem reports: http://cygwin.com/problems.html
FAQ: http://cygwin.com/faq/
Documentation: http://cygwin.com/docs.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple