This is the mail archive of the
ecos-devel@sourceware.org
mailing list for the eCos project.
How to clear status of interrupt in pic
- From: sumanth <sumanth dot kondlada at wipro dot com>
- To: ecos-devel at ecos dot sourceware dot org
- Date: Tue, 9 May 2006 06:15:28 -0700 (PDT)
- Subject: How to clear status of interrupt in pic
Hi all,
I am porting ecos to xscale Ixp425 processor , the interrupt
status register of the ixp425 at address 0xC8003000 according to intel's
manual on reset should contain 0x0 but my board is containing 0x3FF080C0 ,
by this the processor is asserting interrupts even the interrupt has not
occured, and the code is looping between the isr and dsr.
How to clear the interrupt status register of the pic, it is read only,
I am using the axd debugger for debugging.
I have tried by reading the register contents, stil it does'nt clears.
How to solve the problem?
Thanks in advance
Regards,
Sumanth
--
View this message in context: http://www.nabble.com/How-to-clear-status-of-interrupt-in-pic-t1584415.html#a4299639
Sent from the Sourceware - ecos-devel forum at Nabble.com.