This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
Connecting gdb to AEB
- To: ecos-discuss at sourceware dot cygnus dot com
- Subject: [ECOS] Connecting gdb to AEB
- From: Andreas dot Karlsson at combitechsystems dot com
- Date: Wed, 5 Jul 2000 11:39:46 +0200
Hi!
While following the "Getting Started with eCos" you shall connect to the
board using these gdb commands.
(gdb) set remotebaud 38400
(gdb) set mips-force-32bit-saved-gpregs
(gdb) target remote COM1
This set mips.. command, should I replace it?
Entering the command I get:
(gdb) set mips-force-32bit-saved-gpregs
Error: No symbol table is loaded. Use the "file" command.
/Andreas