Re: [ECOS] GDB error

[Bart Veer <bartv at ecoscentric dot com>]

>>>>> "Evandro" == neuwald  <neuwald@inf.ufsc.br> writes:

    Evandro> Hello,

    Evandro> I want install gdb-6.3 for mips-tx39-elf target, but when
    Evandro> I used the comand make:

    <snip>

Please do not post the same message twice. There are many reasons why
you might not get a quick response to a question. Maybe nobody knows
the answer, or the people who do know the answer are currently busy
doing other things. People do not get paid for answering questions on
ecos-discuss, it is a volunteer thing. If you are worried about the
unlikely event of the mailing list software dropping a posting, you
can check the archives at http://ecos.sourceware.org/ml/ecos-discuss/

When it comes to toolchain issues like this ecos-discuss is not
normally the appropriate forum. Instead you should ask on a gdb
mailing list, see http://sourceware.org/gdb/

The MIPS TX39 toolchain support is fairly old. I am not sure it gets
much use or testing these days, so the code may have suffered from
bitrot. One possibility is to try an older version, say 5.1, although
then there is a risk that the code no longer builds because of
host-side changes - especially under Windows. 

These days are alternatives to simulators, e.g. the synthetic target
for Linux users (make sure to use anoncvs eCos rather than 2.0), or
the PC target using some old PC hardware that is lying around.

Bart

-- 
Bart Veer                       eCos Configuration Architect
http://www.ecoscentric.com/     The eCos and RedBoot experts


-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss