This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: Serial support for arm board
- From: "Dave B. Sharp" <daveb_sharp at yahoo dot ca>
- To: Andrew Lunn <andrew at lunn dot ch>
- Cc: eCos Discussion <ecos-discuss at ecos dot sourceware dot org>
- Date: Thu, 27 Oct 2005 15:33:09 -0400 (EDT)
- Subject: Re: [ECOS] Serial support for arm board
I have been looking for gdb with Redboot to no avail,
however I beleive I am about to find out otherwise.
Can you point me to some info and, can I use gdb in
"exec" mode, since at that point I beleive there will
no longer be any Redboot support (however I could
wrong on this too).
Cheers
Dave
--- Andrew Lunn <andrew@lunn.ch> wrote:
> On Thu, Oct 27, 2005 at 02:57:13PM -0400, Dave B.
> Sharp wrote:
> > The serial support is simply for output. Since
> there
> > is not gdb debugging support (I am assuming)
>
> Why are you assuming this?
>
> > I am resorting to printf() development and
> debugging. If there is a
> > better way then I am all ears. Other than that, I
> just want to be
> > able to see something work before proceeding. The
> "wedge" is
> > intended to be a program that is started by
> Redboot, does its thing,
> > then in turn will start up the Linux kernel, such
> as with a layer in
> > a protocol stack.
>
> So why not incorporate this functionallity into
> RedBoot?
>
> Andrew
>
__________________________________________________________
Find your next car at http://autos.yahoo.ca
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss