This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: Using a different network driver
2007/12/17, Andrew Lunn <andrew@lunn.ch>:
> On Mon, Dec 17, 2007 at 08:55:20AM +0100, Antoine Zen-Ruffinen wrote:
> > Hi !
> >
> > I am new to eCos. I want to use it on a soekris board
> > (www.soekris.com), a single board PC, that have 3 NS DP83816 NIC. I
> > have seen that a compatible driver for that NIC already exist in eCos
> > tree.
> >
> > My question is how to incorporate it in my eCos configuration ?
> >
> > I tried with the configtool, but it allways tell me "Add or remove
> > hardware package by selecting a new hardware template".
>
> You cannot add new hardware to an existing target. You need to add a
> new target. Take a look at the pc_i82544 target as an example. You
> need to replace the two CYGPKG_DEVS_ETH_* lines. One should be the
> generic DP83816 package. The other will be a new package you need to
> add.
>
> You need a hardware dependent package which configures the hardware
> independent DP83816 driver for your specific board. Take a look at
> /devs/eth/powerpc/moab/current/ for an example of this.
>
> Andrew
>
After a lot of pain, it work !!! Tank you for help Andrew !! That is
the second time you help me on my eCos project. If you like I will
pay you a beer, when I will come back to Switzerland (I am now in
Sweden).
If I recompile redboot with my new target, will I have network support
in it ? because downloading code trough the serial is very slow.
Antoine
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss