This is the mail archive of the
ecos-patches@sourceware.org
mailing list for the eCos project.
Re: HELP : SUPPORT FOR A91SAM7X256
- From: vibisreenivasan <vibi_sreenivasan at cms dot com>
- To: Andrew Lunn <andrew at lunn dot ch>
- Cc: ecos-patches at ecos dot sourceware dot org
- Date: Mon, 01 Sep 2008 13:25:27 +0530
- Subject: Re: HELP : SUPPORT FOR A91SAM7X256
- Organization: CMS
- References: <1219660260.3256.38.camel@localhost.localdomain> <20080825122229.GO20652@lunn.ch> <1219902376.2787.12.camel@localhost.localdomain> <20080828054155.GG25863@lunn.ch>
- Reply-to: vibi_sreenivasan at cms dot com
hello,
Is there any document or links on how to configure ecos on
linux host.
thanks & regards
vibi sreenivasan
On Thu, 2008-08-28 at 07:41 +0200, Andrew Lunn wrote:
> On Thu, Aug 28, 2008 at 11:16:16AM +0530, vibisreenivasan wrote:
> > hello,
> > How can i know which all peripherals are already supported for
> > at91sam7x256.
> > actually i am looking at
> > I2C
> > SPI
> > ETHERNET
>
> Look at the source code tree? If you are going to use eCos you will
> need to do this anyway.
>
> This will partially answer your question. It is taken from
> packages/ecos.db.
>
> Andrew
>
> target at91sam7xek {
> alias { "Atmel AT91SAM7XEK evaluation board" at91_at91sam7xek }
> packages { CYGPKG_HAL_ARM
> CYGPKG_HAL_ARM_AT91
> CYGPKG_HAL_ARM_AT91SAM7
> CYGPKG_HAL_ARM_AT91SAM7XEK
> CYGPKG_IO_SERIAL_ARM_AT91
> CYGPKG_DEVS_FLASH_AT91
> CYGPKG_DEVS_SPI_ARM_AT91
> CYGPKG_DEVICES_WATCHDOG_ARM_AT91WDTC
> CYGPKG_DEVS_USB_AT91
> CYGPKG_DEVS_ETH_PHY
> CYGPKG_DEVS_ETH_ARM_AT91
> }
> description "
> The at91sam7xek target provides the packages needed to run eCos on an
> Atmel AT91SAM7X-EK evaluation board."
> }
>