This is the mail archive of the
gdb@sources.redhat.com
mailing list for the GDB project.
Gdbserver with powerpc
- From: stefania magistrali <s dot magistrali at selta dot it>
- To: gdb at sources dot redhat dot com
- Date: Fri, 01 Feb 2002 16:30:29 -0100
- Subject: Gdbserver with powerpc
Hi all!
I am developing a powerpc (860) board. I need to compile gdb for my host
(Intel with Linux) and gdbserver for target. I configured the system
like
this:
for gdb: ./configure --target=powerpc-linux
and for gdbserver: ./configure powerpc-linux (then I set CC=cross
compiler
for powerpc)
I have problems with gdbserver, I can't compile it. There are 2
problems:
1) when I compile it, the utils.c file loads the server.h file and this
loads the ../defs.h file (gdb/defs.h) where it is included the config.h
file
(gdb/config.h). But that file is created when I configured gdb (with the
host=Intel and target=powerpc) and so, p.e. it is defined
HAVE_SYS_REG_H,
when I haven't the file sys/reg.h for powerpc. Have I to configure it in
a
different way?
2) In low-linux.c there is a source code for Intel and m68k, I have to
add
code for powerpc? If so, do you know if someone has already done it?
Thanks,
Stefania