This is the mail archive of the
gdb@sourceware.org
mailing list for the GDB project.
Re: gdb/gdbserver uclibc illegal instruction
- From: Paul Blacquiere <blacq at slingshot dot co dot nz>
- To: gdb at sourceware dot org
- Date: Fri, 3 Feb 2006 13:27:24 +1300
- Subject: Re: gdb/gdbserver uclibc illegal instruction
Resolution in thread: Re: Howto single step from beginning
Built uclibc from snapshot dated 02/02/06 - this fixed the issue.
----- Forwarded message from blacq@slingshot.co.nz -----
Date: Mon, 23 Jan 2006 17:12:24 +1300
From: Paul Blacquiere <blacq@slingshot.co.nz>
Reply-To: Paul Blacquiere <blacq@slingshot.co.nz>
Subject: gdb/gdbserver uclibc illegal instruction
To: "gdb@sourceware.org" <gdb@sourceware.org>
Hi,
I am attempting to run gdb/gdbserver on an Arm Linux board built using the
uclibc libraries.
Attempting to run an app causes an illegal instruction error (the simple hello
world app obviously runs normally). One oddity is that the address that it
reports seems to contain a valid arm instruction.
I have seen some old posts on the forum, but being over two years old and
previous versions, I have ignored.
My uclibc version is 0.9.28
GCC 3.4.5
Linux kernel 2.6.12
GDB 6.3 (am building 6.4 at the moment)
Any thoughts or comments welcome and appreciated.
PaulB.
----- End forwarded message -----