This is the mail archive of the
insight@sourceware.cygnus.com
mailing list for the Insight project.
Re: configuring for arm-elf-gdb
- To: "javelina" <javelina at home dot com>
- Subject: Re: configuring for arm-elf-gdb
- From: "Andy Hare" <ahare at btinternet dot com>
- Date: Sun, 5 Mar 2000 23:36:31 -0000
- Cc: "Insight Mail list" <insight at sourceware dot cygnus dot com>
- References: <38C2CE44.39261317@home.com>
Hi
I have been building Insight-GDB under cygnus b20.1 under NT. Below is
the following rules extracted from a makefile that I use to build all the
GNU toolset.
.PHONY: config-insight
config-insight:
cd /c/cygnus/build/insight ; \
rm * -r ; \
/c/cygnus/GNU-Source-Code/insight/configure -v \
--prefix=/c/cygnus/xgcc-arm/insight \
--exec-prefix=/c/cygnus/xgcc-arm/insight \
--host=i586-cygwin32 --target=arm-elf >configure.out
.PHONY: clean-insight
clean-insight:
cd /c/cygnus/build/insight ; \
make clean
.PHONY: insight
insight:
cd /c/cygnus/build/insight ; \
make -w all install LIBGCC2_DEBUG_CFLAGS="-g1 -O1" LANGUAGES="c c++" >
make.out 2>&1
These allow me to configure and build the Insight system, I have been using
it both in the simulator mode and to connect to the ATMEL EB01 eval. board.
Andy Hare
----- Original Message -----
From: javelina <javelina@home.com>
To: <insight@sourceware.cygnus.com>
Sent: Sunday, March 05, 2000 9:14 PM
Subject: configuring for arm-elf-gdb
> Greetings,
>
> I am an ecos user and I would like to use the insight package to do GUI
> remote debugging on an ARM evaluation board. Looking at the mailing
> list archive, it appears that others have done this, but it is not clear
> to me what the steps are to build "arm-elf-gdb" instead of "gdb".
>
> Thanks,
> L3
>
>