This is the mail archive of the
insight@sources.redhat.com
mailing list for the Insight project.
RE: Angel not present
- To: larwe at larwe dot com
- Subject: RE: Angel not present
- From: Daniel dot Andersson at combitechsystems dot com
- Date: Mon, 19 Mar 2001 17:58:35 +0100
- Cc: insight at sourceware dot cygnus dot com
Hi again,
>set remotebaud 9600
>target rdi /dev/ttyS0
>(or com1 or whatever is appropriate for your installation)
I have tried the above but i dont seem to have the rdi (i assume that this
is another word for Angel...). When i do i get the:
Undefined target command: "rdi COM1"
Do i have to issue a special parameter when i build gdb to have rdi (angel)
in my installation?
/Daniel
Just before you press Enter on the target line, reset your board. Within a
couple of seconds of pressing Enter, you should see the Angel sign-on
message on the gdb console, and a couple of seconds later you'll be back at
the gdb prompt.
However note that this arrangement (gdb talking to angel) is at best very
fragile. I haven't tried it with the Insight graphical front-end. If you
have problems, try using gdb --nw to run gdb in raw console mode.
If you're running on a chip vendor's eval board, crosspost to the eCos
discussion list to see if someone there has maybe created un unsupported
port of gdb stubs for that board.
=== Lewin A.R.W. Edwards (Embedded Engineer)
Work: http://www.digi-frame.com/
Personal: http://www.zws.com/ and http://www.larwe.com/
"Und setzet ihr nicht das Leben ein,
Nie wird euch das Leben gewonnen sein."