This is the mail archive of the
insight@sources.redhat.com
mailing list for the Insight project.
Insight5.1 with target dbug
- From: "Andy Lewis" <Andy dot Lewis at multitone dot com>
- To: <insight at sources dot redhat dot com>
- Date: Mon, 11 Feb 2002 13:57:50 +0000
- Subject: Insight5.1 with target dbug
I am trying to use Insight5.1 with an uptodate copy of cygwin to debug on Motorola's M5272C3 Coldfire evaluation board using their dBUG monitor.
I have built Insight with target=m68k-elf.
File->Target Settings does not offer dbug, so I have selected Remote/Serial (+ set baud and com port) , then used the "Console Window" to select "target dbug /dev/com2".
At this point I can display memory and registers from the view menu.
When I try to RUN or Download I get an error message "Downloading my_file .elf to Remote/Serial" "You can't do that when your target is 'exec' "
If I repeat the "target dbug /dev/com2" in the console window the select Run->Download again it works - but ends with a "Timeout reading from remote system".
.data is shown as :0x00028090 .. 0x00028090 ie zero length (this is correct) but maybe that is confusing things ?.
At this point if I adjust PC SP etc I can step through my code.
Are there fixes for any of these problems or do I need to do something else in my config.
Andy
Disclaimer
****************************************************************************
If you are concerned with the content, or have received this email
in error, do not open any attachment but email to
postmaster@multitone.com deleting this message from your system.
A full copy of the Multitone email disclaimer text can be found at
http://www.multitone.com/disclaimer.html
** This email was scanned for viruses, vandals and malicious content **
****************************************************************************