This is the mail archive of the
insight@sources.redhat.com
mailing list for the Insight project.
Re: GDB with USB support
- From: Keith Seitz <keiths at redhat dot com>
- To: Kevin McGrath <kevinmcgrath2003 at hotmail dot com>
- Cc: "insight at sources dot redhat dot com" <insight at sources dot redhat dot com>
- Date: 03 Oct 2003 09:26:11 -0700
- Subject: Re: GDB with USB support
- Organization:
- References: <Law9-F63DNFYHpZP5ui00002faf@hotmail.com>
On Fri, 2003-10-03 at 06:13, Kevin McGrath wrote:
> In relation to writing USB support for GDB, the problem is where do I start.
> I've purchased the development board from cypress & read about the remote
> serial protocol, however where do I start writing the USB code within GDB as
> I should keep the RS232 & ETHERNET support as it is. Is there some sort of
> switch statement within GDB where it decides or does it go through some sort
> of initialisation process first to decide, in any case where is this code
> located, what steps in relation to USB should I take. Also, if you've any
> useful information on this topic, I would appreciate it.
Your best bet is to ask the gdb folks this question. There are many more
gdb developers than there are here. People there are typically quite
friendly and helpful. ;-)
gdb a_t sources d_o_t redhat d_o_t com
Keith