This is the mail archive of the
cygwin@sourceware.cygnus.com
mailing list for the Cygwin project.
usertools installation
- To: cygwin at sourceware dot cygnus dot com
- Subject: usertools installation
- From: Robert Strunce <startech at mindspring dot com>
- Date: Fri, 07 Apr 2000 11:29:40 -0400
I am running windowsNT service pack 4
I down loaded the usertools.exe from one of your suggested sites.
It was down loaded into C:\temp\usertools.exe
It is about 3MB. I also read the info on installing.
I double clicked on ustertools.exe
it created a folder "pft98~tmp" but it did not give me any information that
is had done so.
I clicked on it a again and noticed that it was infact unpacking some stuff
as noted in a small dialog with a thermaometer bar -- it disapeared without
any info. Now I have a folder "pft99~tmp". I tried to delete these
folders and start over but it deleted everything in them but setup.exe
which it will not delete.
HOW DO I DELETE YOUR SETUP.EXE???
NEXT , DO YOU HAVE INFO ON HOW TO INSTALL AND WHAT TO EXPECT. THE README
FILES I READ ON THE WEB DID NOT HAVE THE CORRECT INFO AS TO WHAT HAPPENED
TO ME.
SO WHAT AM I DOING WRONG.
Any help would greately be appreciated.
Regards, Bob Strunce (703-759-2933)
============================================================================
===
Robert Strunce || voice: 703-759-2933
Star Technologies Corporation || fax: 703-759-3266
10303 Galpin Court || cell: 703-629-2933
Great Falls, VA 22066 || internet: startech@mindspring.com
USA ||
--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com