This is the mail archive of the
mailing list for the Cygwin project.
Re: socat with IP6 support?
- From: Andrew Schulman <schulman dot andrew at epa dot gov>
- To: cygwin at cygwin dot com
- Date: Fri, 09 May 2014 06:01:54 -0400
- Subject: Re: socat with IP6 support?
- Authentication-results: sourceware.org; auth=none
- References: <20140117213255 dot GA1843 at ednor dot casa dot cgf dot cx> <20140117221946 dot GA22079 at calimero dot vinschen dot de> <CAF+jOM3YUtgtae5L=kTmaChYRGQYrp6yGg9H8CbFQ3GguW5-0Q at mail dot gmail dot com> <20140118114751 dot GC22079 at calimero dot vinschen dot de> <6nnpd9tm0hn3od1ch642flc0upuvr15jau at 4ax dot com> <20140120172758 dot GA2357 at calimero dot vinschen dot de> <r9mnm955ummb5mktvm8u4eds49eatpsjab at 4ax dot com> <20140508201034 dot GB2645 at calimero dot vinschen dot de> <vhdom9pj43vhf22gavk23ks6g2md18t1uc at 4ax dot com> <20140509084727 dot GE2645 at calimero dot vinschen dot de>
> > To copy file1 to file2 on the localhost, run:
> > socat tcp6-listen:7777 file2
> > to set up a listener, and:
> > socat tcp6:[::1]:7777 file1
> > to connect to the listener and transfer the file.
> > If you have two hosts, you could try the same, running the first command
> > on the server, and the second command substituting the ipv6 address of
> > the server in place of ::1.
> Testing this on 64 bit, with socat 220.127.116.11, and a Linux peer in both
> directions works fine.
> Do you need a test of the 2.0 test version as well?
Yes please, since 2.0 is where I had to apply a patch to remove the use
of IPV6_DSTOPTS. I do have an ipv6 host here that I tested it on, but
it would be good to have another test.
Problem reports: http://cygwin.com/problems.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple