This is the mail archive of the
mailing list for the Cygwin project.
Re: Error Installing Cygwin (setup-x86_64.exe & setup-x86) - No setup.ini.sig found.
- From: Ken Brown <kbrown at cornell dot edu>
- To: cygwin at cygwin dot com
- Date: Sat, 17 Oct 2015 08:13:18 -0400
- Subject: Re: Error Installing Cygwin (setup-x86_64.exe & setup-x86) - No setup.ini.sig found.
- Authentication-results: sourceware.org; auth=none
- References: <CACoLpU-VJqaNv5VQo0sYfDkVLfK5wDw+Usvg29QsAS6M7BwitQ at mail dot gmail dot com> <8737xawn6j dot fsf at Rainer dot invalid> <56216C25 dot 6090104 at cornell dot edu> <878u72eyy2 dot fsf at Rainer dot invalid>
On 10/17/2015 3:28 AM, Achim Gratz wrote:
Ken Brown writes:
Could you check if the setup.ini.sig file is just not stored to disk and
that setup would commence installing if you downloaded it manually and
put alongside the setup.ini file?
Is there a new requirement that a local repository has to have a
signature file? And does it have to be setup.ini.sig (rather than,
for example, setup.bz2.sig)?
You can always tell it to not check the signature (--no-verify / -X),
but if the directory you set it upon looks like a mirror and has a setup
file, then it will by default want to check the signature (belonging to
the actual suffix used: .xz, .bz2 and lastly .ini).
I maintain my own small repository at a remote site and mirror it on my local
machine. It contains, for each architecture, setup.ini, setup.xz, and
setup.xz.sig. Installation from the remote site works fine. If I try to
install from my local mirror, setup complains that it can't find setup.ini.sig.
I can install from the local mirror only if I add setup.ini.sig.
Problem reports: http://cygwin.com/problems.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple