usertools installation update
Robert Strunce
startech@mindspring.com
Fri Apr 7 08:34:00 GMT 2000
UPDATE
see PRVIOUS MESSAGE BELOW
I rebooted my NT,
executed usertools.
went to folder it created
ran setup.exe
installed ok
I went back and it now let me delete all extra folders including the
setup.exe in them
regards, Bob Strunce
PREVIOUS MESSAGE
I am running windowsNT service pack 4
I down loaded the usertools.exe from one of your suggested sites.
It was down loaded into C:\temp\usertools.exe
It is about 3MB. I also read the info on installing.
I double clicked on ustertools.exe
it created a folder "pft98~tmp" but it did not give me any information that
is had done so.
I clicked on it a again and noticed that it was infact unpacking some stuff
as noted in a small dialog with a thermaometer bar -- it disapeared without
any info. Now I have a folder "pft99~tmp". I tried to delete these
folders and start over but it deleted everything in them but setup.exe
which it will not delete.
============================================================================
===
Robert Strunce || voice: 703-759-2933
Star Technologies Corporation || fax: 703-759-3266
10303 Galpin Court || cell: 703-629-2933
Great Falls, VA 22066 || internet: startech@mindspring.com
USA ||
--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com
More information about the Cygwin
mailing list