problems w/ cygwin-1.1.2

[Srinivasa Valiveti]

Hi, 
   I am trying to use cygwin-1.1.2 on NT SP3. I went
thru the installation process (via setup etc). The
installation process goes thru without any problems.
However, when I try to use any program from the bin
dir (even ls) it takes an awfully long time to finish.
Even "ls" seems to take atleast a few seconds (upto 10
secs at times) to finish. Similar times are observed
w/ running bash. It seems that the time delay is quite
independent of the program being run -- something that
makes me suspect the cygwin.dll. Needless to say, this
has prevented me from using this version. I had
experienced similar problems w/ cygwin-1.1.1. I have
found that my 1.5 yr old Cywgin-B20 works "normally". 


(Please note that I DON'T have two versions of cygwin
on my computer -- I went thru the painful process of
installing the new version (over the modem), only to
uninstall it and install my old version back) 

Could anyone please shed light on this? It will be
quite good to move to the latest cygwin release. 

Thanks!
 Srinivasa Valiveti

__________________________________________________
Do You Yahoo!?
Kick off your party with Yahoo! Invites.
http://invites.yahoo.com/

--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com