"command not found"-For All Commands

[physicist25]

I did send the results of cygcheck...some slight changes since...

"I ran cygcheck, its also attached as a .txt file. Notice how I had to add a
"/" to the command to run it."

-sh-3.2# cygcheck -s -v -r > cygcheck.out
-sh: cygcheck: command not found
-sh-3.2# cygcheck/ -s -v -r > cygcheck.out
cygcheck: dump_sysinfo: GetVolumeInformation() for drive D: failed: 112
-sh-3.2# 


I did this again, same results except now I dont have to use "/" when i
write "cygcheck", the results of running the command are the same.

http://old.nabble.com/file/p28725344/nocommandswork.txt nocommandswork.txt 
-- 
View this message in context: http://old.nabble.com/%22command-not-found%22-For-All-Commands-tp28722920p28725344.html
Sent from the Cygwin list mailing list archive at Nabble.com.


--
Problem reports:       http://cygwin.com/problems.html
FAQ:                   http://cygwin.com/faq/
Documentation:         http://cygwin.com/docs.html
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple