Configure second sshd on the same machine
Larry Hall (Cygwin)
reply-to-list-only-lh@cygwin.com
Thu Aug 14 16:43:00 GMT 2014
On 08/14/2014 12:27 PM, Achim Gratz wrote:
> For building 32bit packages I've set up an additional installation on the
> same server. To use it from the outside (like) I'm trying to configure a
> second sshd on the server. So I've installed a cygserver23 and sshd32
> service with otherwise identical setup to their 64bit brethren and bumped
> the port sshd listens on to 3222. The services are starting without any
> hitch, the port is listening and I can log in via public key or password as
> I chose. The only problem: after sending the command to the new ssh
> session, the server closes the connection, claiming that the client had
> disconnected. the client gets an exit code 5. Does that ring a bell with
> anyone? I can't find any error in the config. Even when I shut down the
> 64bit installation completely and let sshd run on the standard port I'm
> getting the same result.
The only time I've seen that is when I start the server in debug mode.
--
Larry
_____________________________________________________________________
A: Yes.
> Q: Are you sure?
>> A: Because it reverses the logical flow of conversation.
>>> Q: Why is top posting annoying in email?
--
Problem reports: http://cygwin.com/problems.html
FAQ: http://cygwin.com/faq/
Documentation: http://cygwin.com/docs.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
More information about the Cygwin
mailing list