Doing vfork: resource temporarily unavailable
Achim Gratz
Stromeko@nexgo.de
Wed May 27 00:14:00 GMT 2015
Rockefeller, Harry writes:
> Instructions above state running setup-x86.exe not setup-x86_64.exe.
> Does anyone experience frequent emacs vfork errors running 64-bit Cygwin?
> Maybe it's time for me to try running that again?
DLL collisions are _much_ less likely on x86_64 out of the gate, but
they do occur from time to time.
> What I've successfully done, twice :-), to fix my vfork errors is to follow the
> above procedure: run rebase-trigger, stop all Cygwin, then run setup-x86.exe,
> followed by a reboot, then bring up cmd window where I run,
> cd c:/cygwin; cd bin; ash; /usr/bin/rebaseall -v
That's the wrong procedure. You run
rebase-trigger fullrebase
then reboot (if you have reason to suspect that a reboot might help,
then run setup.exe (either architecture). An additional rebaseall
beyond that isn't going to do anything useful. A full rebase on the
same installation is deterministic, it will always chose the same base
addresses.
Regards,
Achim.
--
+<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk Blofeld]>+
SD adaptations for Waldorf Q V3.00R3 and Q+ V3.54R2:
http://Synth.Stromeko.net/Downloads.html#WaldorfSDada
--
Problem reports: http://cygwin.com/problems.html
FAQ: http://cygwin.com/faq/
Documentation: http://cygwin.com/docs.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
More information about the Cygwin
mailing list