stty icrnl

[Achim Gratz]

I'm trying to connect to a development board via a (USB) serial line.  It's
using CR rather than NL for line ends, so I was hoping for stty to set that
up so I could use screen to communicate with that board.  No such joy on
Cygwin since the cooked modes are not implemented apparently.  Connecting
via screen anyway lets me send commands to the board with no problems, but I
cannot see any output (presumably because screen waits for the line end ?).
 I can dump the output into a pipe and see it, but of course not at the same
time screen is connected.

Is there some other terminal emulator/program that would let me use this
board anyway via Cygwin until Cygwin learns cooked mode for terminals?


Regards,
Achim.


--
Problem reports:       http://cygwin.com/problems.html
FAQ:                   http://cygwin.com/faq/
Documentation:         http://cygwin.com/docs.html
Unsubscribe info:      http://cygwin.com/ml/#unsubscribe-simple